Neurotic CD/DVD Packaging?

By Kevin

I recently purchased a CD from Target with a nearly intact case and outer plastic wrapping, but the CD had been removed without breaking the seal. When I returned it to the counter, the associates were NOT surprised. Hence, I understand the commercial need for better theft protection. Some others don't:

But what really struck me is how neurotic Hollywood still is with regard to packaging.... Think about how long it actually takes you to open a CD after you've purchased it. It's hard enough to find a loose piece of plastic on the shrink-wrapped packaging so that you can tear through to the inside of the CD container. But after completing that laborious task... you're still only about a third of the way there. Now you must find a way to remove the clear, plastic sticker from the front cover of the CD - you know, the one that is apparently applied using Super Glue....

The DVD market is beyond obsessed; they're paranoid! As we all know, they use the same hard-core plastic shrink-wrap packaging that the CD industry uses. But loathe to use just one of those Super Glue-based stickers on the spine, they use three of them -- one on the spine, one on the top and one on the bottom of the DVD case. This is ridiculous. It is impossible to cleanly remove all the, apparently, theft-proof packaging and leave the DVD case intact.

What is going on here? Is DVD theft really that bad?

What struck me about that article was not the redundancy of all that plastic, or "Hollywood"'s implicit indifference to consumer experiences, but the path that has led us to such tight packaging, and the paths already leading us away from it.

I don't think I need to demonstrate that multiple small pieces of plastic adhered with super-glue is a low cost front-end solution to theft, although it imposes removal costs on the consumer, and downgrades the overall experience.

But, theft actually is that bad, which seems to justify attempts to seal packages with plastic strips, and ugly, clunky, and intrusive cages for each jewel case:

The current furor surrounding illegal internet downloading has overshadowed the age-old problem of theft from shop floors. Which can be anywhere from 1% to 10% of the stock....
Note that alternative anti-theft technologies do exist:

CD and DVD packs are increasingly being designed with the aim of fending off would-be thieves as well as being lightweight, strong, and with branding opportunities aplenty. At its most basic level, case makers are adding internal lips and extra hub security to make it more difficult for the in-store thief to steal the disc out of the case....

The Red Tag security system from AGI Amaray, producer of the Amaray DVD-Safe case, integrates a disk and case locking mechanism with the possibility of tagging.

The case is locked and the disc secured by inserting a security slider at the retail stage. The disc is locked on the hub and cannot be removed without either destroying the disc or the case. The slider can be removed easily and quickly at the point of sale. Having proved immensely successful in Australia, the system is also being further developed in the UK and continental Europe.

This is just like those tags on clothing that have to be removed at the counter; I look forward to these visually appealing solutions on my local CD and DVD racks.

Comments


Bob Hawkins wrote:

I use an M-8 bayonet to open CD and DVD cases.

-- September 7, 2004 3:00 PM


Kyle wrote:

one quick comment. the best way to open a CD:

1. run the bottom of CD jewel case along table edge or similar surface.

2. pick open the bottom hinge of the jewel case, separating entirely the top and bottom of the jewel case. this should allow you to easily peel each side away from the white tape that runs along the top of the jewel case.

Don't have a quick solution for DVDs, they are truly a pain in the neck.

-- September 9, 2004 2:46 AM


Jay wrote:

Quick comment about this-

"The Red Tag security system from AGI Amaray, producer of the Amaray DVD-Safe case, integrates a disk and case locking mechanism with the possibility of tagging.

The case is locked and the disc secured by inserting a security slider at the retail stage. The disc is locked on the hub and cannot be removed without either destroying the disc or the case. The slider can be removed easily and quickly at the point of sale. Having proved immensely successful in Australia, the system is also being further developed in the UK and continental Europe."

Unfortunately, these have appeared in stores such as HMV. As all their dvds are seal wrapped, they dont tell you about this red tag thing. Once you get the dvd home, and cant open it, the only solution is to destroy the case.

-- November 8, 2006 2:26 PM


Emily wrote:

Jay, i just had that same problem today, i had no clue what it was so i just researched it..

the DVD was celophane wrapped OVER the red tag, so even if they had known what the hell it was they couldnt have removed it without taking the cellophane off first....

extremely annoying i have to return it tomorrow now, rather than watching it like i'd planned... that's unless i can figure out how to remove it myself without breaking anything ;)

-- January 25, 2007 4:23 PM


Jadalina wrote:

I just ran into this for the first time today (the red tag lock). What a collassal pain in the ass. I got these used from the movie rental place, and of course they didn't bother to remove them. I figured out how to jam a nail file down the side and wrest one side up enough to open the case. Then, you have to carefully BEND the DVD just enough to shove one of the "Push Me" buttons back to get the one side off, then you can pop the other off. Then rip that red thing out and tear it into tiny pieces. So far I've managed to just break a little piece off the case, and this 3d one I just did, no breakage at all.

It's just effin SAD I have to go through this for something I paid for.

-- July 6, 2007 3:52 PM


Jymbob wrote:

I just got two of these with the tags still in.
I think the seal is magnetic. I managed to open one of them by force (slight cosmetic damage to the case, but I've got spares), and there are metal tracks holding the red tag in place.

I took the second one to the nearest magnet (fridge door) and with the magnet at the middle edge on the back, pressed a flathead crewdriver into the top of the tab and pulled. Came straight out.

Magic.

-- October 20, 2007 3:24 PM


Anon wrote:

Thanks for the tips, we just encountered this with 2 DVDs we'd bought from Coles in Australia so they were really useful.

We found out a little more detail though so in case anyone else needs this for unlocking DVD cases for DVDs they PAID for... (silly shops..)

We figured out that you need 2 really strong magnets. Holding the DVD with the lock symbol towards you (you'll need a friend) you need to put one magnet underneath the bottom end (on the left side) and one above the top end (right side) and then use something to slide the lock bar across. There are magnets that lock the bar in place so these need to be moved out of the way before you start to slide it with a nail file, or screwdriver or knife. (Make sure you have the polarity of the magnets right too - you can waste a lot of time otherwise!!)

This is MUCH easier to do with a clear case than a black one, as we discovered! Oh, and make sure you pull out the lock bar after it's unlocked, if it shuts again you'll have to go through the whole process again. Hope this is useful to other people who'd rather figure it out themselves than return to the shop...

-- November 16, 2007 9:23 PM


wavy wrote:

removing red tags...yeah, if you have a couple of clamps, it works to clamp a rectangular fridge magnet to each side of the red tag and then you have your hands free to remove the suckers with a flat head screwdriver or other such device.

hooray.

-- December 23, 2007 11:12 PM


alex.p wrote:

i hate those red things
what i did was i bent the Cd a little bit then just a little so i could press the button then i took the Cd out and i snapped the red bit into three bits take the start at the pointy end and work your way along when you get to the end its nearly impossible to remove last bit but what i did was snap 1 side of what is holding he square bit in then slide it out sideways through the crack

-- December 25, 2007 5:17 AM


Anonymous wrote:

i have just opened A DVD With the red tag on it. it was quite simple really

1st you need flat head screw driver, and plyers

slide the screw driver into the top of the tag and apply a bit of pressure,(as if you were opening the dvd) it should now open.

next slide the screw driver under the tag (inside box) then turn the screw driver so that the tag is now raised.

then use the plyers to pull the tag out of the dvd case. this should work as the metal rails on the tag should be offset due to the screw driver.

and then watch your dvd, enjoy
any questions email me

-- May 1, 2008 4:42 PM


Anon wrote:

Thanks for everyones suggestion.
Mission accomplished!!
Part of the magnetic strip runs right across the middle of the back of the casing.

Requires 2 -3 women
Half a bottle of wine - optional
1 x magnet (the stronger the better)- essential!
1x small flat-head screwdriver

What isn't obvious is that part of the red tag is a strip going right across the width of the DVD Casing - holding in place the centre button, preventing the DVD from being released.


Instructions:

Put the magnet on the back of the CD case - in the middle.
Slide the magnet towards the spine of the case, keeping it in the mid-line. (i.e the opposite side to the opening)
Then prise the red tag out (using screwdriver if necessary, although if your magnet is strong enough, the strip might just fall out if you tip the case sideways.)


(absolutely ludicrous system of security... :|)

Good luck!

-- May 4, 2008 4:58 PM


James wrote:

guys its just two magnetic pieces, one slightly bent which catch on the plastic and one acts as an anchor for when it goes in the detagger. The only way you can get it out is 2 super high power magnets or if u use a knife you can flick open the case and then whip out the disc and destroy the tag. Interesting once you see how it works!

-- June 3, 2008 8:03 AM


Camille wrote:

what crap.

After all that stress and hard work. i gave up and destroyed everything (:
Have fun attempting to do the same.....

-- September 4, 2008 3:26 PM


BurnOmatic wrote:

the best magnets to use are cattle butthole magnets, they are used to stick in cows buts to move around in there incase they ate wire from the hay bails, farmers use them for that purpose, and they are very strong , the look cylindrical

like this , [img]http://www.northerntool.com/images/product/images/2507238_lg.jpg[/img]

-- November 3, 2008 12:35 AM


beth wrote:

THIS STUPID THING! WE HAVE BEEN WANTING TO WATCH HIGH SCHOOL MUSICAL 3 AND WE CANT OPEN IT!

-- February 16, 2009 3:30 PM


Charlie wrote:

What a doddle, just opened one of these in about 5 minutes and absolutely NO damage to the case or disc.
Use a sharp craft knife and cut around the edge of the exposed red tag, about 2mm in. Cut away a rectanugal slot and a small piece of metal will drop out. This seems to simply re-inforce the device only and once out, the case will easily pop open without damage.
Once the case is open, the remainder of the rectangular part of the tag will easily snap off from the long spine part that runs through the case and holds the disc in box. Once this is done, carefully open the case wide, remove the paper insert and use a feeler guage or similar to push the long part of the tag through the case TOWARDS the spine of the box. The tag is locked to pull outwards, but will push inwards, so removal by pushing through the box works very easily.
Happy lad is now watching his disc.

-- December 25, 2009 5:21 AM


Post a comment